![Fritsch ANALYSETTE 28 IMAGESIZER Operating Instructions Manual Download Page 34](http://html.mh-extra.com/html/fritsch/analysette-28-imagesizer/analysette-28-imagesizer_operating-instructions-manual_2338409034.webp)
4.
Tilt the lens backwards and remove the flat rail runner upwards.
5.
Unscrew the lens from the camera, attach the rear lens cap and
store in the accessory case.
6.
Now, as described in
Chapter 4.7.1 ‘Connection of the camera to
the lens and insertion’ on page 24, connect the other lens to the
camera and place it in the device.
5.1.1 Adjusting the camera angle
The lenses are preassembled with the holders in such a way that all that
is left to do is screw them to the digital camera. If, however, a lens is
twisted out of position, it is possible to correct this:
1.
Attach the camera to the lens.
2.
Remove the 2 hexagon screws closest to you.
3.
Turn the lens until the camera is once again correctly aligned with
the lens.
4.
Once this position has been found, fix the lens in place again with
the two hexagon screws.
5.
Now the lens is positioned correctly in the lens holder.
5.2 Dry measurement
5.2.1 Installing the feeder and funnel
The U-shaped channel is supplied with the large funnel and the V-shaped
channel is supplied with the small funnel.
The two feeders are installed in the same way:
Using the device
- 34 -