/ / FDS TWIN SCREW PUMPS / / /
22
12 Appendix 2 – Assembly instructions
(optional) for pump with bare shaft
12.1 Safety notice
These assembly instructions are intended exclusively for quali-
fied personnel.
12.2 Application
These assembly instructions are valid for pumps supplied wi-
thout a motor (optional). Initially, the pump is an incomplete
machine.
Fig. 15
Incomplete machine: Pump without motor, coupling and base frame
The following information from the “original operating guide”
for complete machines is not valid in this case:
–
Chapter 11.5 “EC declaration of conformity”, page 21
,
–
Chapter 2.5.2 “Nameplate”, Page 7
12.3 Nameplate
12.4 Transport without motor
Transport may only be carried out by trained personnel.
The pump may be transported by forklift or by crane.
Always transport pump in the installation position.
12.4.1 Safety notices
Falling or unsecured components
Severe bruises.
Always wear safety shoes during all transport work.
Incorrect transport position of the pump
Leakage of corrosive, toxic or contaminating fluids. Personal in-
jury and property damage caused by contamination.
Always transport pump in the installation position.
Open, unsealed pipe connections
Property damage caused by contaminants, impacts or moisture
in the pump.
Do not remove the pipe connection covers until immedia-
tely prior to connecting to the pipes.
12.4.2 Transport by forklifts
Unsecured components
Death by crushing, bruising of limbs, property damage.
Secure the pump against toppling prior to transport. Secure
onto the pallet using transport straps or bolt the pump onto
the pallet.
Preparation
Check whether the pump is adequately secured on the pal-
let. For instance using straps
Procedure
1. Pick up the pallet using the forklift.
2. Carefully transport the pallet to the destination and deposit
there.
