- 22 -
v03
1
2
60 mm
2 3/8"
20 mm
0 25/32"
3
Height adjustment
Mounting on an underframe table
Fig. 1
Other supports
Before leveling the unit itself make sure that
the support (table, shelf, underframe table) is properly
levelled.
Choice of front leg
Fig. 2
Our appliances are delivered in a standard version,
assembled with a 20 mm leg. We also deliver a
60 mm leg so that you can choose the most suitable
leg at the time of installation.
Use of the 20 mm leg requires protective
foam to be placed under the appliance. See chapter
“Installation Options”.
Our appliances are built all on the same
level. This means that the tank is connected to the
body. Adjusting the height of the tank therefore also
adjusts the height of the body. This adjustment can
only be carried out by adjusting the back legs of the
appliance. This should be done as follows:
Crushing hazard!
»
Be careful not to crush fingers
whilst handling the appliance
»
Be careful not to let the
appliance tip whilst handling it.
Step 1
Fig. 3
Appliances are delivered with the legs fully screwed
into place. Before adjusting the height we recom-
mend you unscrew each leg by:
» 2 turns if you are using the 20 mm front leg
» 5 turns if you are using the 60 mm front leg
