Frigomat GX2 A, Use And Maintenance Manual

Page: 47 / 124

ENGLISH - 16
2. Condensation pressure (water models
only).
With the machine in production mode, after a
few seconds condensation water must come
out of the drain pipe at a temperature of about
35°C. If this is not the case, the pressure switch
valve shown in the figure must be adjusted.
Three-phase machines are powered with three-
phase + neutral lines: be careful never to
connect
the phase lines with neutral.
FRIGOMAT will not be held liable for damage
to the machine deriving from non-compliance
with this rule.
•
Operating temperature should be between 15° and 35°C.
•
Humidity should be between 30 and 60%.
FRIGOMAT s.r.l. will not be held liable for personal harm and/or damage to objects
deriving from incorrect installation and/or by failure to comply with work accident-
prevention standards. Never intervene on the machine with your hands, neither during
normal operating cycles nor during cleaning and maintenance, without first having stopped
the machine by the main selector (OFF)
and having turned off the master switch. Never
clean the appliance using a high-pressure water jet. Never shut the water cut-off cock
while the machine is running. Be careful never to damage the power cable. If so, have it
replaced.
Machines with water cooling which are left in places at a temperature below or close to
0°C, must first have all the water drained from the condensers.