background image

Summary of Contents for GLMB186CB1

Page 1: ...tladon is flae rcsponsibilily of the installer Product failure due to improper installation is not covered under the Warranty This kit is UL and CUL listed for installation alone or over any Frigidaire single electric wall oven FOR YOUR SAFETY WARNING _f rebeginning the installation switch power off at service panel and lock the smwice disconnecting means to prevent power from being switched on ac...

Page 2: ...ap of the Trim Frame over the edges of the cutout On 30 76 2 cm models allow 1 2 5 cm at lhe lop 2 V_ 5 6 cm on the sides and I V_ 3 5 cm at the bottom for overlap of the Trim Frame over the edges of the cutout INSTALL BOTTOM BRACKET AND BOTTOM DUCT Disconnect the microwave oven before proceeding with the installation Faslen lhe botlom bracket to the bottom duct by using two V2 screws _ Screws 2 R...

Page 3: ...TALL SIDE DUCT AND UPPER DUCT Connect the side duct to the upper duct as shown 1 Insert projecting labs of the upper duct into the holes of Ihe side duct 2 Bend the tabs up with caution as shown NOTE Remove any oil or dirt on the surface of the microwave oven before the ducLs are attached UpperDuct J_ L3Tabs i1 2 SideDuct Set the microwave upright being careful not to bend the front flange Remove ...

Page 4: ...holes through the posidoning flange and i tt then install three 2 screws at the front of the bottom duct as shown I _ INSTALLING THE TRIM FRAME Place the tlJm frame over the microwave oven Make sure the trim frame is level and the microwave oven is centered within the tlim frame Mark four center positions through the four mounting holes of the trim frame NOTE Center the tIim frame equally on all f...

Reviews: