Page 1: ...nstallation for future reference NOTE The electrical service to the washer must conform with local codes and ordinances and the latest edition of the National Electrical Code ANSI NFPA 70 Contents SUBJECT PAGE Pre lnstallation Requirements 2 Electrical Requirements 2 Grounding Requirements 2 Water Supply Requirements 2 Drain Requirements 2 Rough In Dimensions 3 Location 3 Unpacking 3 Installation ...
Page 2: ...wire No 18 minimum from a top panel hinge screw on the rear of the washer to a grounded cold water pipe DO NOT ground to a gas supply pipe or hot water pipe 4 Grounded cold water pipe MUST have metal continuity to electrical ground and MUST register no more than 25 ohms resistance It MUST not be interrupted by plastic rubber or other electrical insulating connectors such as hoses fittings washers ...
Page 3: ... remove foam shipping base Using a ratchet with 3 8 socket remove the mechanism shipping bolt and plastic spacer block from the center of the base NOTE If the washer is to be transported at a later date the tub blocking pad shipping bolt and plastic spacer block should be retained 3 Return the washer to an upright position 4 Remove the tape holding the lid shut and open the lid 6 7 Remove the foam...
Page 4: ...siphoning action 8 Plug the power cord into a grounded outlet NOTE Check to ensure the power is off at a circuit breaker fuse box before plugging the power cord into an outlet 9 Turn on the power at a circuit breaker fuse box 10 Read the Operating Instructions and Owner s Guide provided with the washer They contain valuable and helpful information that will save you time and money 11 Run the washe...
