Frigidaire FREEZER/REFRIGERATOR GLASS DOO, Owner'S Manual

Page: 4 / 45

4
Front Fixed Caster Installation
•
Put two (2) carriage bolts through the rear (non-brake) side of
the fixed caster and hold the carriage bolts loosely in place by
threading several turns each on the locking nuts. Do not tighten
the bolts yet.
•
Hold the caster in position, insert the carriage bolt heads into
the slots near the front of the caster rail and slide the caster
back.
•
Insert the two (2) front carriage bolts thru the top side of the
caster rail and then thru the front holes on the caster. Attach
locking nuts to each.
•
Tighten all locking nuts securely using a ½ inch end wrench or
socket wrench (see Fig. 3).
•
Repeat the same procedure for the other fixed caster.
Carriage
Bolts
Carriage
Bolts
Fixed
Caster
Brake
Front of
Caster Rail
Locking
Nuts
Rear Swivel Caster Installation
•
Place a washer on a long bolt and then feed the bolt through
the hole in the swivel caster.
•
Next, insert the caster bolt through the hole on the metal spacer
and then thru the rear hole of the caster rail (see Fig. 4).
Caster Rail Installation
•
Holding the swivel caster in place, align the caster rail assembly
with the right hand bottom side of the unit.
•
Thread the caster bolt into the hole in the bottom-most foot
pad on the base rail.
•
Tighten the bolt securely using a ½ inch end wrench or socket
wrench (see Fig. 5).
•
Repeat the same procedure on the left hand side with the
other swivel caster and caster rail assembly.Fig. 6
Swivel
Caster
Washer
Bolt
Swivel
Caster
Swivel Caster
Bolts
Washers
Spacer Plates
•
Place a washer onto a long bolt and slide bolt through the
hole located just behind the fixed caster at the front of the
caster rail.
•
Align bolt with the hole in the front foot of the right hand base
rail. Thread bolt into the hole and tighten securely using a ½
inch end wrench or socket wrench (see Fig. 6).
•
Repeat the same procedure for the left hand caster rail
assembly. After installation, tip the unit up with the help of an
assistant.
Appliance Placement
Leave a one (1) inch space on all sides and the back of the
cabinet for ease of installation, proper air circulation and electrical
connections.
DO NOT block the front grill on the lower front
of your appliance . Sufficient air circulation is essential for the
proper operation of your appliance. Choose a place that is near
a grounded electrical outlet. For the most efficient operation,
the appliance should be located where surrounding temperatures
will not drop below 40ºF (5ºC) or exceed 110ºF (43ºC). Additional
compressor heaters are not recommended.
Bolt
Bolt
Washer
Washer
Fig. 4
Fig. 5
Fig. 6
Fig. 3