13
BEFORE YOU CALL
PROBLEM
POSSIBLE CAUSES
SOLUTIONS
Dishwasher won’t
start
• Dishwasher won’t start.
• Power supply or power
line is not connected.
• Delay option has been
selected.
• Control Lock activated
(select models).
• Shut the door completely make sure it
is latched.
• Check and connect the power supply.
• Refer to Delay section in this manual
to reset.
•
Deactivate the Control Lock, refer to
Control Lock section in this manual.
Dishwasher beeps
at the end of the
cycle
• The wash cycle will beep
to indicate the end of the
cycle.
Dishwasher
operates too long
• The dishwasher is
connected to cold water.
• The cycle time will vary
due to the soil.
•
The sanitize option is
•
Check the dishwasher, make sure it is
properly connected to the hot water
supply.
•
When heavy soil is detected, some
cycles will automatically increase the
cycle time.
•
When sanitize option is selected, the
cycle time will be increase to meet the
sanitized temperature request.
Dishes are not
clean enough
• Water pressure is
temporarily low.
• The inlet water
temperature is low.
• Dishes are loaded too
close together.
• Improper use of detergent.
• The selected cycle is
not suitable for food soil
condition.
• Spay arms is blocked by
some items.
• Use you dishwasher when the water
pressure is normal.
• Make sure the dishwasher is connected
to the hot water supply Try not use
your dishwasher when hot water is
being used elsewhere in the house.
• Load the dishes again as per the
manual.
• Add detergent depending on the water
hardness and the cycle you chose. Use
fresh detergent.
• Choose anther cycle for longer washing
time.
• Make sure the spay arm is rotated
freely.
Dishes not
dry enough
• Rinse aid dispenser is
empty.
• Improper loading of
dishes.
• The cycle you chose did
• Fill rinse aid dispenser or increase the
amount of rinse aid.
• Load the dishes again as the manual
instructs.
• Choose the proper cycle with drying.
Spots and film on
dishes
• Water hardness is too
high.
• Improper loading of
dishes.
• Old rinse aid is used.
• Rinse dispenser empty.
• For extremely hard water install a
water softener.
• Load the dishes again as the manual
indicates.
• Use fresh rinse aid.
• Add rinse aid to the dispenser.
Before calling for service, review this list. It may save you both time and expense.
This list includes common experiences that are not the result of defective workman-
ship or material in your dishwasher.