2
Error code chart
Error
code
Fault condition
Check
E11
Fill time too long.
Refer to test (1).
E13
Water leak in tub or air leak in air bell.
Refer to test (2).
E21
Water not pumping out fast enough.
Refer to test (3).
E23
Drain pump relay on control board failed or wire off pump.
Replace control board or wire.
E24
Drain pump relay on control board failed or wire off pump.
Replace control board or wire.
E31
Pressure sensor not communicating with control board.
Refer to test (4).
E35
Pressure sensor indicates water overfill.
Refer to test (5).
E36
Control board problem.
Replace the control board.
E41
Control board thinks the door switch is open.
Refer to test (6).
E43
Control board problem.
Replace the control board.
E44
Control board problem.
Replace the control board.
E45
Control board problem.
Replace the control board.
E46
Control board problem.
Replace the control board.
E47
Board thinks the door PTC circuit is open in spin.
Refer to test (7).
E48
Board thinks the door PTC circuit is closed.
Refer to test (7).
E52
Bad signal from tacho generator.
Refer to test (8).
E56
High motor current.
Refer to test (9).
E57
High current on inverter.
Refer to test (9).
E58
High current on motor phase.
Refer to test (9).
E59
No tacho signal for 3 seconds.
Refer to test (10).
E5A
High temperature on heat sink caused by overloading.
Test first-if bad-rpl speed control brd.
E5B
High temperature on heat sink.
Replace the speed control board.
E5C
High temperature on heat sink.
Replace the speed control board.
E5D
Communication problem.
Refer to test (11).
E5E
Communication problem.
Refer to test (11).
E5F
Communication problem.
Refer to test (11).
E66
Heating element relay failure.
Refer to test (14).
E67
Input voltage on microprocessor incorrect.
Refer to test (15).
E68
Current leakage to ground on heater or fuse opened.
Refer to test (14).
E71
Wash NTC failure. (Tub heater)
Replace control board or wire.
E74
Wash temperature does not increase.
Place NTC in correct position.
E75
Water temperature sensor circuit.
Refer to test (12).
E76
NTC temperature for the cold water valve over the limits.
Hot and cold water hoses switched.
E82
Console control problem.
Replace the control board.
E83
Console control problem.
Replace the control board.
E91
Comunnication error between UI board and control board.
Check wiring.
E93
Console control problem.
Replace the control board.
E94
Console control problem.
Replace the control board.
E95
Communication error.
Replace the control board.
E97
Console control problem.
Replace the control board.
E98
Console control problem.
Replace the control board.
EB1
Incoming power frequency out of limits.
Refer to test (13)
EB2
Incoming line voltage above 130 VAC.
Check voltage at the outlet. If below
130 VAC, replace the control board.
EB3
Incoming line voltage below 90 VAC.
Check voltage at the outlet. If above
90 VAC, replace the control board.
EF1
Clogged drain pump.
Unclog the drain pump.
EF2
Too much soap.
Advise customer to reduce the amount
of soap they are using.
EBE Console control problem.
Replace the control board.
EBF
Console control problem.
Replace the control board.
EF5
NTC temperature for the hot water valve over the limits.
Hot and cold water hoses switched.
134
87970
0
A
(0
702
)