Frigidaire Affinity 6000 Series, Service Manual, Page: 8 / 74

Section 1 Basic Information
1-6
Control
The control is mounted to the back of the console.
(See Figure 1-3) The control:
1. Provides power to the dispenser solenoids, wax
motor, door lock solenoid, drain pump and speed
control board.
2. Sends signals to the speed control board to tell it
what program to run and the heater control board to
control the heater.
3. Checks the status of the door switches, door light
switch, incoming water sensor and the drum water
sensor.
Drum Light Assembly (On select models)
The drum light assembly is made up of a 12 volt AC, 5
watt light that is embedded in the bellows, a push
button switch that is closed when the door is open, and
a step down transformer that reduces the voltage from
120 Volts to 12 Volts. (See Figure 1-4)
A circuit in the electronic control turns the light off when
the door is left open for more than three minutes.
(See Figure 1-6)
Door Switch Assembly
The door switch assembly, located behind the front
panel, is a safety feature that prevents the washer from
operating when the door is open and locks the door in
the spin cycle. (See Figure 1-5)
Door Lock Assembly
The door lock assembly is made up of a coil, door
switch, switch actuator, locking fork, wax motor,
auxiliary switch and spin lock arm. (See Figure 1-7)
Figure 1-3. Control
Figure 1-4. Drum Light
Figure 1-5. Door Switch
Figure 1-6. Light Control
Drum Light
Door Switch
Drum Light
Control