Page 1: ...For New Construction install Frigidaire Wall Sleeve Part EA108T Remove old air conditionerand inspect sleeve forthe following Installation Make sure that sleeve is securely installed and in sound structural condition Dimensions Measure the size to make sure the air conditioner will fit Slope There should be a rearward slope for condensate to drain from the rear of the sleeve Check against Fig A 1 ...
Page 2: ...r conditioner 2 Clean the interior of the sleeve do not disturb seals 3 Repaint the sleeve if needed 5 If thewall sleeve already has a reargrille skip to step 7 If the wall sleeve does not have arear grille or Iouvered panel install the plastic grille from the kit Cut the plastic mesh to match the sleeve installed Place the plasticgrille to theinside of thewall sleeve at the rear flange Place the ...
Page 3: ...able below Depth D of the existing wall Length A sleeve inches inches 20 D_ 20 20 D 2 I_ I _ 213 4 D_ 24 4 12 Slide trim over thefront ofthe airconditioner until trim is flush with sleeve as shown below Fig J NOTE Be sure to route the cord through the trim frame before placing the trim frameon the unit 10 Remove the backing from the support blocks and attach them to the inside of the wall sleeve a...
