Lite
3
List Number L110N WHI
BEFORE STARTING ANY INSTALLATION WORK, PLEASE READ CAREFULLY
TOOLS NEEDED
●
Drill and 6mm Masonry Drill Bit
●
Wire cutters and Wire Strippers
●
No.2 philips Screwdriver
●
Terminal or Electricians Screwdriver
●
Large Flat Bladed screwdriver
PARTS INCLUDED
- Bulkhead PIR light
- Instruction Manual
- Accessory pack
Instruction Manual
SAFETY
Always follow the manufacturers advice when using power tools, steps, ladders etc. and wear suitable
protective equipment (e.g. safety goggles when drilling holes). Before drilling holes in walls, check forhidden
electricity cables and water pipes, the use of a cable/pipe locater maybe advisable if in doubt.
The mains supply to this product should be installed by a competent person (e.g. a qualified electrician) in
accordance with these instructions and in accordance with the appropriate clauses of the current edition of
the IEEE wiring regulations (BS7671).
DANGER - 230 VOLTS. To prevent the risk of electrocution, always turn off the mains electricity supply
before commencing any work on the installation or opening the detector.
It is essential that all connections are made as instructed, that cables are not stressed and that terminals
are fully tightened.
Suitable for connection to fixed luminaires only. Internal and connected lamps loads must not exceed the
specified maximums. This product is suitable for wall mounting only.
