Service Instructions
Page 90
Service Manual Deli Multisserie form 9123560 rev. 09/2017
General
When one of the bottom welds is broken, it is advised to
drill all 4 holes from the template like in the above des-
cription. Consider to do this for all 3 doors at the same
time.
When one of the top welds is broken, you could decide
to fix only this weld by mounting a bolt on both sides of
the weld.
The template has a laserline, which can be used to drill
holes on any point of choice.
In case the weld is not broken, but the channel is too
wide, a shim is available. A good channel is between
10mm, and an absolute maximum of 11mm (25/64”-
27/64”).
Place the shim at the bottom side in case of bottom
repair and place it at the top side in case it concerns the
channel at the top. This is because the gasket has to be
pushed towards the cooking cavity. Put silicon between
the shim and the plate. The next time that the gasket has
to be replaced, the shim will then stay on its place.
Putting in a new doorgasket.
It is recommended to spray a mild soap mixed with water
on the gasket before pushing it in the channel. The gas-
ket is then better capable to settle itself and it makes the
work easier.
When the gasket is mounted, also spray the outside of
the gasket with the soap solution before closing the door.
Check if the gasket is not folded when the door is closed.
Specially when the gasket has this shape which is used
untill serial number 100033430!
Example of top repair
Example of broken weld
Shim
Shim in top
channel
