Page 38
Service Procedures
Service Manual Deli Multisserie form 9123560 rev. 02/2017
EXCHANGING THE SIDE POST PIPE AND SPRAYERS
Disassembling the pipe and sprayers.
1. Remove the 3 sprayers [210] including the
nipple adapters [209] from the inside.
Wrench size metric 24.
2. Open the top of the unit. 9 screws
3. Loosen the hoseclamp and take off the
hose. Socket size 7mm
4. Take the pipe out of the side post.
5. Clean the pipe and the thread holes in case
it will be reused.
6. Also clean the holes in the sidepost.
Assembling the pipe and side post sprayers.
1. Make a mixture of the 2 component sealant.
This is 1cc of resin and 8 drops of hardener
for each sprayer.
2. Put the sprayer pipe from the top into the
sidepost.
3. Apply a general amount of mixture on the
outside thread of the nipple adapter.
4. Lift up the pipe, line up the middle hole and
mount a nipple adapter in this hole, hand-
tight.
5. Repeat from step 3 for the other two nipple
adapters.
6. Tighten the nipple adapters with a torque
of 15 lbs.ft. (20 Nm). Use a 24 mm wrench.
7. Remove the redundant sealant.
8. Mount the hose to the pipe at the top.
Note that units untill serial number 100046244
(July 2009) can have the old sprayers with
seal ring. These must be replaced by the
above mentioned nipple adapter and
sprayer. Thoroughly clean the pipe thread
and holes in the sidepost !!
CLEAN !
1/4”BSPp 1/8”BSPp
OLD !!
9191234
1
2
3
4
8
