Fri-Jado BC 3-E, User Manual, Page: 16 / 24

BC
EN 16 / 24
4.6.2 Automatic operation
Action Operation Display (after operation)
1 Switch on the oven The last set baking time
appears
2 Select a programme mode
The LED above lights up
and the last used programme
will appear on the display
3 Select the required programme
/
Selected programme
Now put the
products into the
oven if a
programme
without pre-heating
has been selected
and proceed with
step 6
4 Start the programme
PREh and the LED above is
flashing
5 After the preheating has expired, the
oven will give a sound signal and
Load will flash on the display
Now put the
products into the
oven.
Load , (flashing) The
temperature is not maintained
while loading the products.
6 Start baking the products The set baking time expires
7 After the baking time has expired,
the oven will give a sound signal
and
End appears on the display
Take the products
out of the oven or
press
Last used programme
8 Switch off the oven and go to step 3

The LED above the button will flash while the oven is busy with a process
started by the user. For example, while pre-heating, loading and recipe
processing.

Pressing the button while pre-heating will abort the pre-heating. The oven
will then immediately proceed with baking the products.
4.6.3 View and change the temperature while baking
You can view and change the temperature while baking.
During baking, press the button to make the set temperature appear on the display. You can
change the set temperature using the and buttons.
4.6.4 View and change the baking time while baking
You can view and change the baking time while baking.
During baking, press the button to make the remaining baking time appear on the display. You
can change the set remaining baking time using the and buttons.