Fresenius Medical Care 5008, Operating Instructions Manual

Page: 79 / 328

Chapter 5: Preparation
Fresenius Medical Care 5008 OP 5/09.06 5-29
5.2.10 Checking/Setting the Sodium and UF Profiles
Basic requirements for setting the profiles:
the UF parameters must have been set.
O
Na profiles
In the DIALYSATE MENU
Check the dialysate parameters.
Minimum value that can be set for Start Na: 3 mmol higher than the
prescribed Na
Set the desired profile.
Check/set Start Na (maximum value).
(The minimum Na value is automatically adjusted.)
The following must be observed:
– The treatment may also be started with the Na profile only.
– It is only possible to select matching profile groups.
(E.g. if UF profile 1 has been selected, only Na profile 1 is available.)
– After having started the profiles, it is no longer possible to alter the
Concentrate, Prescr. Na and Prescr. Bic parameters.
– The minimum UF time must be set:
Profiles 1, 2: UF time 2:00 hrs
Profile 3: UF time 3:30 hrs
Set the desired parameters.
Touch the
OK button to confirm the entered values.
Visually check the confirmed values.
Touch the PREPARATION menu button to return to the
PREPARATION SCREEN.
O
UF profiles
In the UF MENU
Check the UF parameters.
Minimum UF parameters that can be set:
Profiles 1, 2: UF goal 200 ml, UF time 2:00 hrs, UF rate 10 ml
Profile 3: UF goal 200 ml, UF time 3:30 hrs, UF rate 10 ml
Set the desired profile.
Check/set the start rate.
(The minimum profile rate is automatically adjusted.)
Caution
When using Na profiles, the following precautions must be observed:
The balancing neutrality of the profiles was computed for a dialysis dose
of KT/V = 1.2. In case of higher deviations (KT/V > 1.4; KT/V < 1.0) the
balancing neutrality may not always be achieved.