freightliner CL112 2015, Maintenance Manual

Page: 146 / 180

9. Check the input shaft for any leakage around the
input shaft seal cover. If there is evidence of
leakage from inside the cover, remove it and re-
place the input shaft seal. See
Group 46 of the
Columbia Workshop Manual for instructions.
Check the steering system pressure and return
lines and fittings for leaks and damaged lines or
hoses. Repair or replace lines, hoses, and fit-
tings as necessary.
NOTICE
Do not tighten the tube fittings on the hard trans-
fer lines. Tightening the tube fittings can cause
tearing of the O-ring seal and increased fluid leak-
age.
f462151
11
17
12
13
14
1
6
7
5
5
9
9
4
4
3
3
18
19
20
21
23
2
10
22
15
16
07/24/2009
8
8
1. Steering Tie Rod Arm
2. Power Steering Fluid Lines
3. Large Bellows Clamp
4. Bellows
5. Small Bellows Clamp
6. Driver-Side Outer Tie Rod
7. Tie Rod Jam Nut
8. Inner Tie Rod Flat
9. Inner Tie Rod Ball Joint
10. Input Shaft Seal Cover
11. I-shaft Upper Yoke
12. I-shaft Lower Yoke Boot Clamp
13. I-shaft Lower Yoke Boot
14. I-shaft Lower End Yoke
15. Transfer Line Tube Fittings
16. Power Steering Fluid Line
Fittings
17. I-shaft Slip Joint
18. Transfer Lines
19. Rack and Pinion Gear
20. Pinch Bolt
21. Tie Rod Clamp
22. Tie Rod Clamp Nut
23. Passenger-Side Outer Tie Rod
Fig. 4, Rack and Pinion Steering System
Steering
46
Columbia Maintenance Manual, September 2015
46/4