freightliner cascadia, Driver Manual

Page: 82 / 238

WARNING
The lane departure warning system is intended
only as an aid for a conscientious and alert
driver. The system may not indicate lane depar-
tures under certain conditions. Read carefully the
information in this manual to understand the cir-
cumstances under which this system may not
provide adequate lane departure warnings. Do
not rely solely on the system to safely operate
the vehicle. The system does not warn of all pos-
sible hazards. For example, the system cannot
prevent an accident if the driver is impaired or
not driving safely.
The lane departure warning system is not a sub-
stitute for safe driving procedures.
Failure to drive safely and use the system prop-
erly could result in personal injury and/or death
and severe property damage.
The lane departure warning system powers up each
time the ignition is turned to ON. The system con-
ducts a self test, and initiates test tones from the left
speaker and then the right speaker. Once the vehicle
is started and the system is ready, the LED in the
switch illuminates.
Press the LANE ALERT switch to temporarily disable
the lane departure warning system. See
Fig. 6.26 .
Some vehicles are equipped with a timer that auto-
matically re-enables the warning system after 15
minutes. On all other vehicles, the warning system
will remain disabled until the driver enables the sys-
tem by pressing the LANE ALERT switch again, or
the ignition is cycled off and then on.
When the vehicle approaches the lane markings on
either side, the system sense the activation of a turn
signal. If a turn signal has not been activated, the
system initiates the audible warning to alert the driver
that the vehicle is departing its current lane of travel.
The LANE SRCHNG warning light illuminates to indi-
cate the system is not fully functional. When the
warning light is on, the system audible alert may not
indicate a lane departure. Conditions that can cause
the warning light to illuminate include:
•
The system is unable to detect lane markings.
•
Vehicle speed is less than 37 mph (60 km/h).
•
A system problem is detected.
Roll Stability System
The roll stability system may include the roll stability
advisor (RSA) only, or it may also include the roll sta-
bility control (RSC).
A decal ( Fig. 6.27 ) on the auxiliary dash panel, and
an amber-colored dash indicator light ( Fig. 6.28 ), in-
dicate that the vehicle is equipped with roll stability
system components.
LANE
ALERT
f611156 01/05/2012
Fig. 6.26, Lane Departure Warning System Disable
Switch
lamp indicates traction
OR roll control event.
Follow instructions in
driver’s manual.
24−01204−000
07/11/2003 f080125
SAFETY INSTRUCTIONS
Fig. 6.27, Roll Stability Decal
06/26/2003 f602128
Fig. 6.28, Roll Stability Indicator Lamp
Driver Assistance Features
6.11