OPERATION
Powering ON and OFF
To activate the MT300-13T, push and quickly release the Power Button. The display will come on in a few
seconds. To put the MT300-13T in Standby mode, push and quickly release the Power Button. To turn the
MT300-13T off for extended storage, power off safely using any software function that “shuts down computer”
provided in the software operating system.
Start Up
If the power up (from Standby mode or otherwise) is successful, the appropriate interface will be displayed
after a launch sequence of several seconds. The wireless LAN connection may take 10-15 seconds to be
established.
Configuring the Mobile Tablet
The MT300-13T may be configured using the utilities and methods dictated by the software operating system.
The MT300-13T should be configurable for various properties such as user profiles, network features, and
several system elements.
Wireless Networking
Wireless LAN
The MT300-13T is often delivered with an embedded (user-inaccessible) 802.11ac WLAN adapter equipped
with a hidden custom antenna.
• Through the support of typical WLAN adapters, the MT300-13T should be able to detect all 802.11 access
points in the vicinity for you to select the access point of your choice for connection.
• The SSID and WEP/WPA/WPA2 (if enabled) parameters on the MT300-13T and the access points have to
match. The SSID is case-sensitive and it is recommended that you enable WEP/WPA/WPA2 encryption (or
advanced alternatives) for secure access.
• When WEP/WPA/WPA2 is enabled, you may need to consult your network administrator or your
networking equipment literature to properly configure associated settings such as Authentication mode, etc.
• Refer to the access point operating manuals for setting up the 802.11 access points.
IMPORTANT NOTE
The battery packs shipped with your tablet may be low in power—please use the AC-DC adapter with the
MT300-13T when setting up for the first time to fully charge the internal battery pack. You may charge the
external battery pack with it attached to the MT300-13T, or with the optional external battery charger kit.
IMPORTANT NOTE
When the batterypack(s) is (are) charging, the blue-colored Battery LED should blink slowly. If plugging in the
AC-DC adapter does not trigger this blinking activity and the LED stays dark, the battery pack(s) may have
been drained substantially. Try unplugging/ replugging the AC-DC adapter to the MT300-13T a few times to
activate the charging process.
IMPORTANT NOTE
To conserve power, use (push and quick release) the Power Button to put the tablet in “Standby” mode while
not in use. Pushing briefly on the same button will wake up the system within seconds.
IMPORTANT NOTE
Avoid using the Power Button (“hold 4+ seconds” feature) to turn off the tablet—this form of hardware
shutdown is intended to be a means of recovery from lockups, and not as normal operation.
freewaymedtech.com
MT300-13T Basic operation guide
