5. Installing and Wiring Components
Figure 31: I/O Slave to the Well Head
5.6.3 Terminal Port Mappings in
Tool Suite
1. Verify that:
a. both the I/O Master and the I/O Slave are configured.
b. the I/O Master can connect to the I/O Slave.
2. Using
Tool Suite
, connect to the I/O Master and select the I/O Settings tab.
3. Map the
Analog Out 1
to
Slave AI1
for the tubing sensor.
Note
: The I/O Slave is listed by serial number.
As there is only one I/O Slave in the network in this example, only one Slave is listed in the port
selection fields.
If there were additional I/O Slaves in the network, each Slave to which the I/O Master is
connected displays in the list.
Page 94 of 131
LUM0008AG Rev Sep-2015
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.
Summary of Contents for FGR2-IO-IOE
Page 131: ......
