The MōVI Controller Receiver included with the MōVI Controller is configured in MōVI Controller Receiver mode by default. It can be changed to an Auxiliary
Transmitter mode if necessary by following the instructions above.
Auxiliary Transmitters purchased separately for follow-focus integration will be preconfigured in either microRemote Auxiliary Transmitter mode or Axis 1 Auxiliary
Transmitter mode depending on the option selected at purchase. However, they can be changed to any other mode at a later date by following the instructions
above.
The MōVI Controller firmware can be updated using the included USB A-A cable. The latest firmware, release notes, and update instructions are available at
www.freeflysystems.com
.
FIRMWARE UPDATE:
User inputs can be recalibrated to fine-tune the center and end-points. Recalibration is not usually necessary, but can be done through
Tx Config::Tx Actions::-
Calibrate
. The following table lists inputs that may be recalibrate by the user, as well as the calibration triggers for each.
Verify that the focus knob end points are correct by viewing the Focus input in the Tx Config menu. It should move from 0.0 to 100.0 over the full range of the
knob, with no dead spots or jumps. To save the new focus knob end-point calibration, use
Tx Config::Tx Action::Save
.
Other inputs are factory-calibrated and cannot be changed at this time.
CALIBRATION:
USER INPUT
CALIBRATION TRIGGER
Focus Knob Right End Point
Focus Knob Left End Point
User 3 Switch Up, then press Menu Set while in
Tx Config::Tx Actions::Calibrate
User 3 Switch Down, then press Menu Set while in
Tx Config::Tx Actions::Calibrate
Summary of Contents for MoVI
Page 1: ...USER GUIDE ...
Page 30: ......
