HANDLE UPGRADE INSTRUCTIONS
Page 1: ...HANDLE UPGRADE INSTRUCTIONS ...
Page 2: ... both Hand Grips on the Upper Cross Bar and slide both grips off the Upper Cross Bar If the Top Handle is installed remove it now Remove Accessory Mount from the Upper Cross Bar if present 03 Attach the Toad In The Hole Quick Release Female Adapter to the carbon plate on the Pan Motor using the 4 supplied M3 10mm socket head cap screws Position the latch of the TITH pointing to the front of the Mō...
Page 3: ...ips onto the new Upper Cross Bar Tighten grips slightly to prevent them from sliding off of the boom during alignment Reinstall your Accessory Mount before reinstalling the Hand Grips 06 To align the Hand Grips properly place the new Upper Cross Bar with Hand Grips on a flat surface rotating the grips as needed Once alignment is set fully tighten Hand Grips If desired insert the Top Handle into th...
Page 4: ...all different sized Upper Cross Bar NOTES If performing Auto Tune with the new 450mm Upper Cross Bar installed loosen the levers of the Clamp Handle Toad and rotate the Hand Grips with the Upper Cross Bar approximately 45 This will allow proper clearance for the motion of the Pan bar while using the Auto Tune function The Clamp Handle Toad is designed to only be used with the new thicker Upper Cro...
