iii
Caring for TOPAZ Ultra
To care for your TOPAZ Ultra, follow these recommendations:
•
When TOPAZ Ultra is not in use and not connected to external power, always turn the power off by
pressing the Power button for two seconds.
•
Ensure that your TOPAZ Ultra is completely off before cleaning it.
•
Clean TOPAZ Ultra
with a soft dry cloth or an electrostatic dusting cloth. DO NOT use liquid cleaners
on its plastic surfaces.
•
To prolong the life of TOPAZ Ultra, remove the battery from the device if it will not be in use for one
week or more.
•
The protective glass covering the camera can be cleaned as needed with the lens cloth provided within
the packaging of TOPAZ Ultra. DO NOT use liquid cleaners on the plastic surfaces. No additional
methods of sterilization or cleaning are recommended or required.
Susceptibility to Interference
There may be temporary degradation of the image when TOPAZ Ultra
is subjected to a strong radio frequency
field, electrostatic discharge, or transient electrical noise. An electrostatic discharge (caused by static
electricity) may cause the screen to go blank. If this happens, follow these steps:
1. Disconnect the DC adapter power supply from the electrical wall outlet.
2. Wait 30 seconds.
3. Connect the DC adapter power supply again.
Additional Electrical Safety Precautions
Read these safety precautions before using TOPAZ Ultra:
•
Use only the power supply provided with your TOPAZ Ultra. Using unauthorized power supplies may
cause serious damage to TOPAZ Ultra’s electronic components. Using any power supply other than
the one provided by Freedom Scientific for TOPAZ Ultra will
void the warranty
.
•
If using DC power, the TOPAZ Ultra device should be near a wall outlet that is easily accessible.
•
Do not use TOPAZ Ultra in, near, or around water. TOPAZ Ultra is not designed to offer protection
against contact with liquids of any kind.
•
Always place the power cord away from traffic areas to avoid damage to the power supply.
•
Prevent the risk of electrical shock by NOT attempting to disassemble the device. Refer all service to
an authorized repair facility.
•
Ensure that you make all proper cable connections.
