1270 Instructions 9-15-14.doc
Page 1 of 5
2014 – Current Silverado/Sierra Bench Seat Models
Qi Wireless Charging Kit (Kit # FDMC-1270)
Please read thoroughly before starting installation and check that kit contents are complete.
Items Included in the Kit:
Tools & Supplies Needed:
Qi Wireless Charging Module with
Silverado/Sierra Specific Substrate and Mat
Power Harness with 3 amp Fuse
4 – Flat Head Torx 1/2" Screws
These Instructions with Template
Removable Consumer Product Label
Plastic Trim Removal Tool
T-10 Torx Driver
Phillips Screw Driver
Center Punch/Scribe Tool
Power Drill
3/16” and 1/2” Drill Bits
Soldering Iron & Solder
(Recommended)
Tape or Heat Shrink Electrical Tubing
*Note this product is designed to work with Qi compatible devices. Please confirm that
your device is Qi compatible before installation. Visit
www.brandmotion.com
for phone
compatibility guide.
Safety Precautions:
•
Work in well ventilated area that is clear of obstructions.
•
Secure vehicle with tire chucks in both front and rear of tires.
•
Turn vehicle accessories OFF and ensure ignition key is in OFF position.
•
Wear safety goggles and snug fitting clothes.
•
Use tools only for their intended purpose and which are in good repair.
•
Only perform this task if confidence, skill, and physical ability permit.
NOTE: We strive to provide accurate and up-to-date installation instructions.
For additional assistance please call Brandmotion Technical Assistance at (734) 619-1250 then dial 2.
IMPORTANT: Do not place smart keys
within 15cm of charging mat. Vehicle
may not detect key to start vehicle. Do
not place metal objects in tray while
charging.
Summary of Contents for FDMC-1270
Page 7: ...consumer to remove label...
