FRC Turbofoam TFC100, User Manual

Page: 45 / 88

TFC100 Rev180215
45
Figure L4. Manual ABF Selector Mounting Dimensions
Panel Cutout
1 3/8" Diameter
4 5/8"
3"
3"
9 1/8"
6"
Panel Thickness
1/4" Maximum
Front Plate is
5" by 5"
4"
Install Manual ABF Selector Assembly (TFC200 Option)
The Manual ABF Selector is for use with the TFC200 on two tank systems.
Note: The maximum thickness for the mounting panel is 1/4".
1. Measure and mark location for the center hole and four mounting bolts. Make sure there is clearance
for plumbing connections before drilling holes. Refer to figure for layout and dimensions.
2. Drill one 1 3/8" center hole and four through holes for the 3/8" bolts.
3. Place the front plate in position, run bolts through front plate, panel, spacers, and valve plate. Secure
with nuts.
4. Connect the handle assembly.
5. Connect the foam tanks, flush water, and foam pump plumbing. (Refer to Plumbing Connections.)
6. Connect the cable to the module. (Refer to Wiring Section.)
The front plate can be used as a template
for marking bolt and hole location.
1 3/4"
2 3/4"
Valve
Plate
Spacers
Front
Plate
3/8"
Bolts
Handle
Assembly
Nuts and
Washers
Through holes on panel are
clearance for 3/8" hardware.
The mounting panel
maximum thickness is 1/4".
2"
Foam B
Port
Flush
Water
Port
Foam
Pump
Port
Foam A
Port
Top View