TGA100 Rev0106
34
High Idle Wiring
The InControl programming includes a high idle function. To activate the high
idle provide a ground to pin 4 (High Idle Active Input) of the 8-pin connector and +12
VDC pin 3 (Interlock Input) of the 12-pin connector. The high idle connection to pin 3
must be isolated form the interlock circuit using two diodes (see schematic).
Note: It is important that the connection to the Interlock Input from the High
Idle circuit be isolated from the apparatus interlock wiring with the two
diodes. Refer to the wiring diagram. The pump must NOT be engaged
when using the high idle function.
The high idle is set at about 1000 RPM at the factory. (This value will vary depending
on the specific engine.) To adjust this setting refer to High Idle in the Operation Section.
A High Idle Kit is available from FRC.
P/N XE-TG38HK-A0A
Includes:
ON/OFF Switch
Indicator Light
Two Diodes
To 12-Pin Connector
Pin 3 White Wire
Interlock Input
To 8-Pin Connector
Pin 4 White Wire
High Idle Active Input
High Idle
ON/OFF
Switch
Diodes
(IN4002 or equivalent)
From
Transmission
Neutral
+12 VDC
Pump
Engaged
Indicator
Light
NC
NO
C
ON
OFF
High Idle
Indicator
Light
GND
From
Pump
Engaged
+12 VDC
GND
NC
NO
C
From
Parking
Brake
GND
NC
NO
C
Figure 13. High Idle Wiring
