DGA200 Rev160525
14
Install Blower Assembly Legs
NOTE :
The 5th leg assembly may be installed on the blower assembly from
the factory.
Parts Needed
1-5th Leg Assembly (3)
8-Socket Cap Screw, 1/4-20, 3/4 inch (1)
4-Flat Washer, 1/4 inch
2-Hex Head Screw, 5/16-18, 2 1/4 inches (4)
4-Flat Washer, 5/16 inch
2-Nut, 5/16-18
2-Hex Head Screw, 3/8-16, 1 inch (2)
4-Flat Washer, 3/8 inch
2-Nut, 3/8-16
Procedure
NOTE:
The side lower screws that hold the blower side legs to transfer tube
do not have washers.
1. Connect blower side legs to transfer tube with eight screws (1) and washers.
Do not tighten screws.
2. Align blower assembly mount holes with leg brace holes and install two screws
(4), washers, and nuts. Do not tighten screws.
3. Tighten blower side legs to transfer tube screws (1).
4. Tighten blower assembly mount screws (4).
5. Install 5th leg assembly (3) with two screws (2), washers, and nuts.
End Procedure
