DFA400 Rev0708
24
Code 321 Flow Calibration (Single Point)
Factory programmed value:
Precalibrated to Pipe Size
Options:
1 Calibration Point
This code starts the calibration program for a single flow rate.
Refer to Calibration Section.
Code 322 Flow Calibration (Multiple Point)
Factory programmed value:
No Values Entered
Options:
9 Calibration Points
This code starts the calibration program for multiple flow rates. This function is
used when the flow sensor is installed in a difficult plumbing location where flow is
not linear. It corrects for nonlinear flow to provide an accurate flow rate display.
Refer to Calibration Section.
Code 340 CAN Terminator
Factory programmed value:
On
Options:
On, Off
This code sets the datalink terminating resistors for this module.
