Page | 26
FRIDGE RESET
If your fridge does not cool, and neither the display nor the interior of the fridge is illuminated, please first
check if the problem can be solved by resetting the fridge. To do this, follow
these steps:
1.
Turn off the fridge.
2.
Turn off the main power and the propane.
3.
Open fridge vent cover at the driver side.
4.
Unscrew and remove the metal silver burner box cover
.
5.
Check if the black reset button
between the two red cables is still pushed in. If it is
not, please push it back in.
6.
Open the propane valve slowly and turn the battery on.
7.
Turn the fridge back on.
If the problem persists, the thermal fuse of the fridge may have blown. Please call our
OnRoad-Service, and we will try to arrange an appointment at a workshop near you. If you
feel comfortable you can alternatively
Bypass the thermal fuse
1.
Turn off the fridge. Turn off the main power and the propane.
2.
Open fridge vent cover at the driver side.
3.
Unscrew and remove the metal silver burner box cover
.
4.
There are the two red wires attached to the reset switch
. One of the wires leads to
the thermal fuse what is attached to lower fridge part.
5.
Remove the screw or metal tab and cut off the black fuse
.
6.
Join the red wires together but do not let the exposed wires touch anything!
7.
Turn propane, main power and fridge back on.
8.
If the fridge starts tape and secure the wires.
The fridge should be working now. The thermal fuse has to be replaced later.
SLIDE-OUT
The RV is equipped with a slide-out. When using the slide-out, please proceed as follows:
1.
Park on a
LEVEL
surface with sufficient open space to extend the slide-out (no inclines,
trees, etc.).
2.
Put the gear selector into the PARK (P) position and remove the ignition key.
3.
There is a double switch for operating the slide-out just inside the camper door. The upper switch must be
in the
ON – Electrical Drive
position. This switch can be left ON and only needs to be set in the OFF – Main
Drive position when operating the slide-out manually.
4.
EXTEND
the slide-out by holding the lower switch into the
OUT
position until slide-out is fully extended.
5.
Hold the switch to the
IN
position to
RETRACT
the slide-out.
CAUTION:
There must not be any heavy objects like suitcases in the slide-out or people sitting at the dinette
while the slide-out is being extended or retracted. Otherwise the motor of the slide-out could
overheat and become damaged.
1
2
3
2
