SOLAR LED
EGGLITE KIT
LSE2-W
ENGLISH
EN
This instruction sheet provides you with the information required to
safely own and operate your product. Retain these instructions for
future reference.
The product you have purchased is of the highest quality
workmanship and material, and has been engineered to give you
long and reliable service. This product has been carefully tested,
inspected, and packaged to ensure safe delivery and operation.
Please examine your item(s) carefully to ensure that no damage
occurred during shipment. If damage has occurred, please contact
the place of purchase. They will assist you in replacement or repair,
if required.
READ THESE INSTRUCTIONS CAREFULLY BEFORE
ATTEMPTING TO INSTALL, OPERATE, OR SERVICE YOUR
PRODUCT. KNOW THE PRODUCT’S APPLICATION, LIMITATIONS,
AND POTENTIAL HAZARDS. PROTECT YOURSELF AND
OTHERS BY OBSERVING ALL SAFETY INFORMATION. FAILURE
TO COMPLY WITH THESE INSTRUCTIONS COULD RESULT IN
PERSONAL INJURY AND/OR PROPERTY DAMAGE!
SAFETY GUIDELINES
WARNING
WARNING:
Risk of explosion. Do not incinerate.
WARNING:
Replace battery with authorized part only. Use of
another battery may present a risk of fire or explosion.
Dispose of used battery promptly. Keep away from children. Do not
disassemble and do not dispose of in fire.
This product has not been investigated for swimming pool or spa
use.
ASSEMBLY
Your Solar LED EggLite kit comes fully assembled with the following
items:
Solar panel with 6-inch cord
Two white LED EggLites
10-foot extension cord with three-way connector
Stake extension
Spare o-ring
If you purchased the above items separately, follow the instructions
below to ensure your unit is correctly assembled. (Skip to step 5 if
you purchased these items as a kit.)
1. To ensure a waterproof connection, place an o-ring onto each
light plug (Figure 1).
2. Insert each of the two light plugs into a three-way connector
receptacle (Figure 2), then tighten the connectors.
IMPORTANT: Align the flat sides on the plugs and the receptacles
for proper polarization. If the plugs are not inserted correctly the
lights will not illuminate.
3. Connect additional lights (sold separately) to the third receptacle
on the three-way connector (Figure 3).
4. Connect one end of the extension cord to the short cord of
the solar panel. Connect the opposite end to the three-way
connector (Figure 3). NOTE: Ensure that the flats are aligned as
previously described.
5. Attach extension to ground stake.
6. Slide the MODE switch to the RUN position (Figure 4). This will
automatically turn the lights off during the day so that the battery
can recharge. It will also turn the lights on during the night
to illuminate your landscape. NOTE: For the automatic on/off
switching to work properly, ensure the photocell (Figure 5) is not
covered and is always exposed to ambient light.
7. Your LED EggLites should now be fully functional. The lights
should turn on with the solar panel in a mostly dark room, and turn
off when the room is well lit.
•
•
•
•
•
1
10’ Low-Voltage Power
Cord
16”
Pliable
Cord
EXTRA LED EGGLITES
COMPLETE SOLAR LED EGGLITE KIT
Solar Panel, Two LED EggLites, and 10’ Low-Voltage
Power Cord
Three-way connector
(up to 6 total)
Figure 3
O-ring
Light plug
Connector
Figure 1
IMPORTANT!
Align flat sides
Three-way connector
receptacle
Light plug
Figure 2
Franklin Electric Co., Inc.
P. O. Box 12010
Oklahoma City, OK 73157-2010
Phone: 405-947-2511 • Fax: 405-947-8720
www.LittleGiantPump.com
