Franklin Electric CERUS X-DRIVE CXD-003A-4V, Installation And Operation Manual

Page: 47 / 252

DRIVE CONFIGURATION
Using the Keypad
47
DRIVE CONFIGURATION
Using the Keypad
Home Screen Display Options
b
Run
H
A
58.7 PSI
60.00 Hz
K/K
2.22 Amp
JOG View . Faults
Auto
LCD Display Screen
Function Keys provide access to
( F1 ) Jog Function, ( F2 ) View
Mode, and ( F3 ) Fault history
The HAND LED indicates when the
VFD is in Hand mode.
The BACK key returns display to
the previous screen. From the first
MENU screen, this key displays a
basic drive menu.
Left and Right Arrow keys allow
navigation between parameter
groups, cursor movement when
setting a value, and for increment
of numeric values.
The HAND key places the VFD in
Hand mode when keypad control
is enabled.
The START key starts the motor
when keypad control is enabled.
The LED indicates that a Start
command is present.
The ESC key returns to the Home
Screen from any menu.
The RUN LED indicates that power
is being sent to the motor.
Up and Down Arrow keys allow
navigation within a parameter
group.
The MENU key provides access for
editing all parameter groups.
Pressing
BACK from this screen
displays a basic drive menu.
The ENTER key places the VFD in
programming mode and confirms
changes to parameters.
The AUTO key places the VFD in
Auto mode when keypad control is
enabled.
The STOP/RESET key stops the
motor when keypad control is
enabled, or if enabled in remote
mode. The LED indicates that the
VFD is stopped. RESET can be used
to clear some faults.
The
FWD/REV
key selects motor
direction when enabled. The LED lights
either green or red to indicate selection.
1. Operating Status
Run/Stop
Limit by PID 2
Ctrl by PID 2
Stopped by AI
Backspin Timer
Lubrication
Limit by Level
Limit by Temp
Stall
2. Command Source
K = Keypad
T = Terminal control
R = RS485
O = Option board
3. Frequency Source
K = Keypad/PID
V1 = from AV1
V2 = from AV2
C = from ACI
R = RS485
O = Option board
1-15 = Step speed
J = Jog frequency
b
Run
H
A
58.7 PSI
60.00 Hz
K/K
2.22 Amp
JOG View . Faults
1 2 3
4
5
6
BT
4. Display Line 1 [SET-57] Use Arrow and Enter keys to step through selections and to change setpoints.
H = Output speed when running (Hz).
P =
PID Set-point [SET–21]
in application based units (PSI, inWC, etc.). This is adjustable using the keypad.
F = Keypad Speed Reference (Hz) when Auto Speed Ref [SET–07] or Hand Speed Ref [SET–09] is set to Keypad . This is adjustable using the
keypad.
5. Display Line 2 Displays motor current.
6. Display Line 3 [SET-58] Use Arrow keys to step through choices. This display corresponds to choices in
[SET–57]
.