Care and maintenance
Cleaning the omni tap
The Omni tap is manufactured in stainless steel and is therefore
extremely durable and stain resistant. All that is required to keep it
in good condition is a regular wipe over with a damp cloth - Franke
offer a micro-fibre cloth for this purpose that can be purchased on
line at www.frankefilterflow.co.uk— and an occasional wash with a
proprietary moisturising hand cleaner or the application of a small
amount of baby oil on a soft cloth or tissue will also help to keep
the finish bright and free of smears.
Changing the batteries in the Filter Cartridge Change
module.
If necessary separate the module from the Velcro pad and slide off
the battery cover at the side of the module. Remove the battery
carrier and replace the two old AAA batteries with two new ones.
Press the reset button.
removing the boiler
1. Disconnect the electricity supply to the boiler.
2. Operate the boiling water function and run the boiling water
until the water flowing from the spout runs cold.
3, Shut off the water supply to the boiler.
4. Operate the boiling water for a second time until the water
stops flowing to release the pressure in the boiler.
5. Disconnect the hoses from the boiler using a suitable container
to catch residual water.
6. Remove the boiler carefully, unscrew the brass drain nut at the
base and pour out the water it contains.
operating the omni tap
the body of the tap is clearly marked to show the
2 functions.
Boiling Filtered water
Remove the red safety clip (3)
Depress the boiling water lever to release the
safety lock and rotate it against the spring pressure.
important note:
The boiling water spring assisted shut-off is
designed to deactivate the boiling water function in an emergency.
The lever is NOT designed to re-centre itself in the OFF position
when released.
Correct operation requires the user to guide the lever back to the
‘’oFF”
position. It is the responsibility of the user to check that
the tap is shut off correctly. The safety clip can only be re-fitted
when the handle is correctly located in the OFF position. If the
lever is just released it will pass through the “OFF” position and
turn the cold filtered water partially on.
the correct way to dispense the boiling water.
Position the outlet of the spout inside the receptacle you are
about to fill (saucepan, cup or jug for example). Operate the
boiling water while gradually lowering the receptacle as it fills.
Cold Filtered water
The cold filtered water function is controlled
by turning the boiling filtered water lever in the
opposite direction, but without the need to depress
the lever to disconnect the safety lock beforehand.
Mains Cold
Mains Hot
Filtered Boiling
Filtered Cold
Removable
Safety
Clip
Mains Cold
Mains Hot
Filtered
Cold
Filtered
Boiling
Removable
Safety
Clip
100°c
Mains Cold
Mains Hot
Filtered Boiling
Filtered Cold
Removable
Safety
Clip
Mains Cold
Mains Hot
Filtered
Cold
Filtered
Boiling
Removable
Safety
Clip
100°c
