Franke 2000100375, Installation And Operating Instructions Manual

Page: 7 / 36

7
ZMI
_001_
2000
1003
75-ZAQ
U
A00
7_#S
EN_#A
QU_#V
2.f
m
10. Electrical Connection
Output characteristic
Connecting the output lines
☞
Apply wire-end ferrules to flexible lines
10.1 Connect the cores of the output line according to the pin configuration on the T-
junction or on the fitting.
SELV power supply - pin configuration
10.2 Connect the output line to the compact system power supply.
10.3 Insert the power plug into the socket.
11. Fault correction
If you are unable to correct a fault or if the fault is not described in the fault correction
section, please inform our service department!
Pin P1 Signal Level Curren
t
Colour C1
1 Not used yellow
2 Not used green
3 GND 0 V white
4 Not used brown
5 24 V 24 V + 0.5 A red
Fault Cause Remedy
No output voltage
present – Voltage supply interrupted
➯
Restore
– Compact system power supply
defective
➯
Replace
– Output load too high (possibly short
circuit)
➯
Eliminate the
source of the fault
on the connected
components