FRANCO srl Manual of use and maintenance AP
13
2 - INSTALLATION
2.1 Before installing
In order to start the AP aerotherm, the following conditions are required:
• connection to the electric power supply with voltage and frequency suitable for
the machine and with grounding and safety devices;
• connection to hot/cold water supply;
•water drain connection.
The installation must meet the safety requirements
provided by local regulation in force.
Make sure that all the connections necessary to operate the equipment have been properly prepared.
2.2 Positioning
The AP aerotherm must be installed horizontally, hanging off the ground, with the condense drain
hole siding down.
Use the threaded inserts for hanging the machine holding it in the correct operating position with
an appropriate fixing system avoiding vibration (the distance between holes is shown in Figure
2.1; use vibrations reducer devices);
AP15 - AP25
AP30 - AP35 - AP40 - AP50 - AP60 - AP70 – AP80 –
AP100
Threaded inserts quotes for suspension / brackets Fig. 2.1
The positioning of the AP must be done by maintaining the minimum recommended distance that allows the
correct operation of the machine and to perform maintenance when needed.
Choose, depending on the type on installation adopted, the most suitable position for the humidification and the
cooling of the environment.
The instalment of the machine must meet the safety distance and protections in
accordance with the norm DIN EN 294 – 4, 4.1, 4.2.
