6
– Operating Instructions
This equipment is designed for use out of doors, in free air. Never place anything on, or cover,
the spotlight when in use as this may present a hazard.
The spotlight can be tilted
35
by pushing or pulling the underdeck handle.
Before switching on the searchlight make sure to remove the plastic film sheet off the front
protective cover.
This product should not be used for any purpose other than for which it was designed.
Any modifications to the product should not be undertaken without consulting the
manufacturer.
7- Fault Finding
All fault finding must be conducted by a competent person or qualified Electrical Engineer.
Failure of LED to light.
In the event of the LED failing to light the following steps should be taken:
Check that the supply is connected to the input of the LED and check all connections
On operation if the LED does not light, switch off supply and check all fuses
8 - Maintenance and Servicing
In order to prolong the service life and performance of your spotlight, the following maintenance
guidelines are recommended:
◼
Maintenance checks should be conducted before every voyage or at least every three
months.
◼
Before checking, disconnect the equipment from the supply.
◼
Visually inspect the condition of the equipment.
◼
Any major or minor structural damage should be rectified immediately in order to reduce
sympathetic wear.
◼
It is advisable to check all seals and gaskets for signs of degradation. Renew if necessary.
◼
Upon completing all maintenance requirements, the spotlight should be tested for full
working order (approximately 20 minutes).
If in any doubt as to the correct servicing procedures to adopt please contact your
distributor/agent or the manufacturer who will be able to advise the best course of
action for your product.
L.ED Unit Replacement
Remove the old LED Unit by releasing the cable gland & undoing the fixings that holds the unit
onto the crutch & then pulling through the cable.
Next feed the cable of the new LED Unit through the cable gland and ball tube.
Attach the LED Unit to the crutch.
