Fractal AXE-FX III, Owner'S Manual

Page: 87 / 124

81
12 SETUP MENU
MIDI/REMOTE: OTHER PAGE
Controller assignments for various other functions of
the Axe-Fx III.
PARAMETER Description
Tempo Tap Provides the ability to tap the tempo using an external controller. Remember that
tempo is calculated using either the last two taps OR an average, as set in the
global Tempo configuration ( p. 67 ). Learn more about Tempo in Section 10 .
Tuner Provides a way to remotely enter or exit the Tuner ( Section 11 ).
Preset Inc/Dec
Preset Inc/Dec Start/Stop
These allow you to step up or down through a sequence of presets with pre-
defined start and end/wrap points. Preset mapping and offsets are ignored.
Scene Select Selects specific Scenes. The controller value (NOT the CC number) determines
which Scene is loaded:
0 = Scene 1
2 = Scene 3 4 = Scene 5 6 = Scene 7
1 = Scene 2 3 = Scene 4 5 = Scene 6 7 = Scene 8
The series continues, cycling through scenes 1–8 for values up to 127 (Scene 8).
For more, see
"Scene Select" on p. 46 or "CC Value to Scene" on p. 112
Scene Increment
Scene Decrement
The Scene Increment and Decrement functions allow you to step up or down
through scenes. These functions are triggered by CC data values above 63.
Input 1,2,3,4 Volume
Output 1,2,3,4 Volume
Eight individual parameters allow you to globally control the levels of the
corresponding Input or Output blocks.
Output 1 Volume Increment,
Output 1 Volume Decrement,
Output 2 Volume Increment,
Output 3 Volume Decrement
These options provide a convenient way to permanently increase or decrease the
MAIN output volume for the Out 1 or Out 2 Blocks in the currently loaded preset.
Each time Volume Increment is triggered, the MAIN is increased by 1.0 dB and
the preset is saved. This is the same for Volume Decrement, except it decreases
volume.
IMPORTANT! Any unsaved changes such as altered effect parameters or
bypass states will also be stored when either of these functions is triggered!
These functions are designed for use with momentary footswitches set up to
send a CC# value of 127 for “ON” and 0 for “OFF”. Do not use an expression pedal
or you could inadvertently increase levels to +20 dB with a single sweep!