IR900
1. IntRoductIon
IR900 is a Digital PIR sensor, with an analysis system that takes into account the two most important changes
that may occur during a movement: the speed and the intensity. With the simultaneous comparison of these two
information, the sensor is able to discriminate repetitive movements from intrusion, lowering the percentage of
false alarms. With hight thermal variations, the totally digital temperature compensation system, guarantees
a great performance. Has 15mt coverage, with angle of 90 °. With the special lens is equipped of creep zone.
To disassemble the detector just press the tooth on the bottom of the case (see figure) and pull out the PCB
by pushing the clip and by levering on the ABS supports (see figure). In this way it will be possible to freely
work on the PCB.
2. InstallatIon pRoceduRe
- By using a thin screwdriver, push the round tooth on the bottom and open the housing (see figure 1)
- Remove the PCB from the base by levering on the ABS supports (see figure 2)
- Pierce the knock on the base of cover on the desired point for fixing,or use the optional swivel bracket.
- recommended height 2mt
- slide the cable into the back seat, and out of the top hole
- Wire up the terminals following the connections shown in figure.
3. adjustments and connectIon
To disable the walk test LED open the
jp2 led
To enable doubble pulse close the JP1
ap: Tamper terminal
alaRm Alarm terminal
supplY: power supply 13.8Vcc
IR900
- code 999741
pir detector
Rivelatore Infrarosso passivo
Installation manual - manuale installazione
saFetY WaRnInGs
• The installation of the product must be performed by qualified personnel in accordance with local laws and regulations on safety. Fracarro Radioindu-
strie therefore is exempt from any civil or criminal liability resulting from violations of existing laws on the matter and arising out of the improper use of
the product by the installer, user or third parties.
• The installation of the product must be carried out according to the installation instructions provided in order to protect the operator from accidents
and the product from damage.
InstallatIon WaRnInGs
• Humidity and condensation drops can damage the product. If condensation, before using the product, wait until it is completely dry.
• Handle with care. Shock improper could damage the product
• Avoid placing the sensor near sources of heat or direct sunlight.
• When mounted to the wall using screw anchors suited to the characteristics of the mounting bracket.
• The product should not be exposed to dripping or splashing water and should be installed in a dry, inside buildings.
GeneRal WaRnInGs
• In case of failure, do not attempt to repair the product or the warranty will be void.
• It is recommended to check for proper operation of the alarm system; However, an electronic alarm system does not reliably prevent intrusion, theft,
fire, etc., but only decrease the risk of such situations occurring.
Fracarro Radioindustrie SRL declares that the product complies with the following standards: CEI EN 50130-4 - CEI EN 55022 - CEI EN 60950 and
therefore complies with the essential requirements the following directive (including all applicable amendments): 2004/108 / EC, Electromagnetic Com-
patibility (EMC). The information in this manual has been compiled with care, however Fracarro Radioindustrie Srl We reserve the right to make changes
at any time without notice, improvements and / or changes in the products described in this manual. Please check our website for www.fracarro.com
conditions Warranty and Support.
