918-211c
-8502-
DIRECT VENT GAS FIREPLACE
09/22/08
-8502-
Regency Direct Vent System Flex Venting Kit
Horizontal Terminations Only
These venting systems, in combination with the Direct Vent Gas Fireplace, have been tested and listed as a direct
vent heater system by Warnock Hersey. The location of the termination cap must conform to the requirements in the
Vent Terminal Locations diagram in the installation manual.
Notes:
1) Liner sections should be continuous without any joints or
seams.
2)
Only Flex pipe purchased from FPI may be used for Flex instal-
lations.
3)
If you are installing into a Regency Mantel Kit, use the minimum
horizontal vent height. Remember to include the mantel base in
your calculations and to maintain the clearance to the underside
of the mantel top.
Page 1 of 2
FPI Direct Vent (Flex) System Termination Kits include all the parts needed to install the Direct Vent Gas
Fireplace using a fl exible vent.
* May also be required in the US. See unit
installation manual for details.
FPI Kit #
Length Contains:
#946-615
4 Feet
1)
5”
fl exible liner (Kit length)
2)
8”
fl exible liner (Kit length)
3)
spring
spacers
4)
thimble
5)
AstroCap
termination cap
6)
screws
7)
tube of Mill Pac
8)
plated
screws
9)
S.S. screws #8 x 1-1/2” drill point
10)
vinyl siding standoff
#946-618
6 Feet
#946-616
10 Feet
