FPG Visair IN-VA10-A004, Product Manual

Page: 11 / 40

IN
– VA10
- 11 - © Future Products Group
Routines
VISAIR CABINETS - OPERATION
After Hours
Ideally, cabinets should not be turned off after hours or at night.
If the cabinet is turned off, transfer the products to a cool store. When the
cabinet is turned on again, allow it to run for 30 minutes before returning the
chilled products.
Cleaning It is recommended that cabinets be cleaned at the end of the working day, since
they need to be shut down for this. See Cleaning section.
De-frost Cycle
Defrosting of the evaporator coil is fully automatic, taking place every two hours.
If you suspect that the defrost system is not working properly, have it checked
by a qualified service person.
Operators must not attempt to adjust the refrigeration controller.
Temperature
Checks
Cabinet temperatures should be routinely checked, to confirm satisfactory
operation.
The refrigeration controller shows the temperature of the circulating air, as it
enters the cooling coil. This will be slightly higher than the air temperature in
the display area, so a temperature probe should be used to check product
temperatures.
To avoid misleading temperature measurements, do not take a readings within
20 minutes of a defrost cycle.
Warning-
Flammable
Products
Do not store explosive substances, such as aerosol cans with a
flammable propellant, in this appliance.
Equipment Disposal
VISAIR CABINETS - OPERATION
Specialist
Disposal Specialist disposal procedures are required for the safe removal of refrigerant
gasses and potentially flammable foam materials.
Pentane, Dimethyl Ether, Isobutene, Butane and Propane may be present.