FPG IN 3C06S, Product Manual

Page: 11 / 56

IN 3C06,09,12,15-SQ
- 11 - © Future Products Group
Preparation
REFRIGERATED CABINETS - OPERATION
Shelf Location
and Ticketing The shelves are adjustable in
height and can easily be moved
up or down, to match product
size.
The movement is restricted to
50mm, because of the electric
cables to the lights. For greater
movement contact the
manufacturer or supplier for
advice, as electrical modifications
may be required.
The front and rear edges of the shelves are profiled to carry ticketing/labels.
Shelf
Adjustment To move the shelf brackets, first remove the shelf
trays.
Lift the brackets straight up firmly and then pull the
brackets forward, to disengage them from the slots
in the support posts.
Insert the brackets into their new position, and
push bracket down firmly.
The brackets may be positioned to give two
different degrees of slope to the shelves.
Refit all shelf trays and doors
.
N.B.
Make sure brackets are pushed down as
far as they can go. Failure to do this may result in shelf collapse, when
loaded with product.
Turn on
Refrigeration The refrigeration condenser will run as soon as the cabinet main switch is
turned ON, and the cabinet temperature will begin to fall.
The temperature controller is pre-set to maintain the cabinet temperature at 2

-
4

C, and should not need adjustment.
Fumes and
Odours Before first use, operate the cabinet for 1-2 hours to remove any fumes or
odours, which may be present. This will avoid possible tainting of food.
Continued on next page