FP PostBase Vision, Reference Manual

Page: 165 / 206

Tips for troubleshooting 165
…
with automatic feeding / sealing (PostBase Vision Feeder)
Envelopes are not sealed. Sealing is disabled.
Set the switch to the ‘seal’ position
(see chapter 6.3.3.2) .
Sealant tank is empty or too low.
Fill more SEALIT sealing fluid
(see chapter 18.9.1) .
Envelopes are not properly
sealed. Stroke your hand firmly over the envelope’s / letter
stack’s flap area.
Moistening sponge and brush are dried because
the sealant tank was empty over a longer period of
time.
Remove basket with sponge and let sponge soak
up completely
(see chapter 18.9.3) .
Sponge is dirty or worn.
Clean or replace the sponge
(see chapter 18.9.3) .
Brush is dirty or worn.
Clean or replace the brush
(see chapter 18.9.4)
.
You have used unsuited envelopes.
Only use envelopes that are suited for sealing by
machine. Observe specifications
(see page 188)
.
Adjust the moistening level (see chapter 18.9.2)
Use SEALIT, sealing fluid available from FP or
authorised FP dealer.
Jam. On how to clear a letter jam, please read chapter 19.3 .
PostBase Vision signals a jam although no letters
are in the letter path.
The sensors (light barriers) are soiled.
Clean the sensors
(see chapter 18.2, page 128) .
Issue Possible cause and remedy