FP S-Compact BB / LAN
44
8
Reset to factory defaults (Factory Reset)
The FP S-Compact can be reset to factory defaults via the ‘Service’ button (only acces-
sible when the housing is open). The SIM PIN is retained.
Disconnect FP S-Compact from the power supply.
Unscrew the housing cover (see page 19).
Keep the housing cover and the four screws in a safe place.
FP S-Compact
without cover
(extract)
Press the ‘Service’ button and keep it pressed.
Re-establish the power supply.
Wait until the ‘Power’ LED (yellow) flashes.
Release the ‘Service’ button briefly.
Press the ‘Service’ button again. Keep it pressed until the
‘Power’ LED flashes rapidly.
Release the ‘Service’ button. The device restarts.
All settings in the device (with the exception of the SIM PIN)
have now been successfully reset to factory defaults.
Fasten the housing cover to the housing with the four
fastening screws. Tighten the fastening screws with a torque
of 0.7 Nm to 1 Nm (0.52 ft lb to 0.73 ft lb).
‘Service’ button
‘Power’ LED
Summary of Contents for FP S-Compact BB
