STU 720V1.0
OPERATING INSTRUCTIONS
7
the STU is in the Music & Radio mode.
TV Servi
ces are rest
ored by pressi
ng TV on t
he RCU,
or TV on
t
he STU f
r
ont
panel
.
NOTE:
When switching from normal to standby then
back to normal, the STU automatically returns
to the previously selected service.
7
The STU is set up to the local default settings by the
manufacturer. If it becomes necessary to change the installation
parameters call FOXTEL on 131 999.
The STU is now ready for normal use.
INSTALLATION OPTIONS
Introduction
There are several ways of connecting the STU to an existing
entertainment system.
The following more common examples enable you to view satellite
services and terrestrial channels, record and playback from a
VCR and listen to CD quality stereo sound on a Hi-Fi.
Consult FOXTEL for assistance in setting up an audio/video
configuration best suited to your requirements.
Hints to Quality TV System Configurations
•
Where possible, connect cables via audio/video outputs/
inputs (SCART or AV) instead of RF connectors.
•
Use an appropriate, correctly installed satellite dish system.
•
Use high quality stereo TV and Hi-Fi equipment.
•
Use high quality screened cables.
NOTE:
When Video and Audio connectors (AV) are used,
it may be necessary to select a Video mode (AV)
on the VCR and TV in place of a TV mode.
STU, TV (using SCART or RF Interface)
NOTE:
As the LNB connection cable carries a small
voltage on its centre connector, it is
recommended that the mains supply to the
STU is switched off before connecting or
disconnecting the LNB cable.
1
Connect the terrestrial antenna connector to the RF IN socket
on the STU.
The following instruction applies if your TV has a SCART
connector.
2
If using a SCART-to-SCART cable (not supplied), connect
theTV SCART socket on the STU to the SCART socket on the
TV.
OR
Using a SCART to RCA connector (not supplied), connect the
TV SCART to the A V connectors on your TV. If only one audio
socket is available on your TV, the mono audio connector
should be used.
3
If required, use an RF signal flylead to connect the RF OUT
socket on the STU to the RF IN socket on the TV.
4
Connect the coaxial cable connector from the LNB on the
satellite dish into the socket marked LNB IN on the STU. The
connector on the coaxial cable should be turned until it is finger
tight.
5
If your TV has a S Video connector, connect to S VHS
connector on the decoder. Also, connect Mono Audio on
decoder to Audio In on the TV, or variable audio if you have a
stereo TV.
Republic of South Africa
WARNING! High Voltage
DANGER! Do not open
Unauthorised opening
renders warranty invalid
Protect against moisture
REAR PANEL
VIDEO IN
AUDIO IN
AV CONNECTIONS
SCART TO SCART
S VIDEO
RF IN
NOTE: CONNECT EITHER RF IN TO RF OUT
OR RCA TO RCA
N4078
