THEA-130 / 160 Sprayer Drone
User Manual
©
2019 FOXTECH All Rights Reserved
6
Rotate the drone horizontally until the LED turns blue and enter the vertical calibration phase, as shown
below:
Then the drone head vertically upwards and rotates. When the LED indicator turns off, then it flashes,
and the calibration is successful. When the LED indicator turns red, the calibration fails and needs to be
recalibrated.
After the calibration is completed, you need to unplug the power to restart the aircraft.
Recalibration is required in the following case:
- The compass data is abnormal: the LED status indicator of the drone indicates that the yellow-green light
flashes alternately.
- The flight field is far from the site where the last calibration of compass was made.
- The mechanical mechanism or the body circuit of the drone has changed.
- Drifting during flight is more serious, or can not fly in a straight line
Work in Manual Stabilization Mode
Unlock, Start the Motor
Before performing the unlocking operation, keep away from the
drone to avoid danger and injury. The motor can be started by
performing the following operations on the remote control.
After unlocking, push the throttle stick above the middle position
and the drone can take off.
Unlock
Push the throttle slowly.
