Foxtech DA16 Radio Control System
User Manual
©
2018 FOXTECH All Rights Reserved
12
Do not fold or cover antennas and avoid any obstruction between transmitter and aircraft in a flight,
otherwise there will be an obvious decrease to transmission signal strength.
DA16 transmitter is equipped with a built-in 3000mAh Li-Po 1S battery. Charging time is generally
between 2.5 to 3 hours using a standard 5V/2A adapter charger. Charging time may be different using
charger with different standards, please pay an attention to transmitter charging indicator in charging.
Each unit of DA16 transmitter is assigned with a unique ID code. Before linking DA16 receiver to DA16
transmitter, receiver must identify transmitter ID(Linking). After the first linking between transmitter and
receiver, the ID code will be memorized in receiver, so that you don’t have to repeat linking next time (except
if the transmitter was linked with a different receiver after that).
Before charging DA16 transmitter, please read the part “READ TIPS - Precautions on Charging DA16
Transmitter” in this manual carefully.
Transmitter charging time is limited by charger’ power output. More power charger adapter has, less
charging time it is.
(1) Choose the right charger for DA16 transmitter;
(2) Make sure that DA16 transmitter is powered off.
(3) Find a Micro-USB cable among accessories
coming with DA16 transmitter packaging, connect
its Micro-USB end to transmitter’s Micro-USB port on
the back, USB end toadapter charger;
(4) Plug charger into adapted AC power outlet;
(5) In charging, transmitter charging indicator is solid
red; charging finished, it turns to solid green.
How to Charge DA16 Transmitter
How to Link DA16 Transmitter to DA16 Receiver
Steps to Charge DA16 Transmitter
Steps to Link
(1) Keep the distance between DA16 transmitter and DA16
receiver within about 1 meter, then power on transmitter;
(2) In DA16 transmitter screen menu, tap on “System Settings –
General Settings”;
(3) On DA16 receiver, stick a pin or needle into receiver’s linking
hole, press and hold linking button for 3 seconds till receiver
status indicator blinks red quickly. Receiver now is ready for
linking;
