Foxpro XWave, Instruction Manual

Page: 58 / 64

58
wait a few moments, turn them back on and try operating
again.
Cannot transfer sound list to
XWave remote Make sure that the remote and caller are set to the same
channel of operation. Keep the remote control in close
proximity to the XWave caller.
XWave remote does not turn
on Try replacing the batteries.
XWave remote stuck on start-
up screen Try replacing the batteries.
External speaker does not
play If you have the speaker connected to the right external
speaker jack, make sure that the right speaker is not
disabled in the XWave remote, and vice versa with the left
speaker jack. The external jacks are linked left/right
accordingly.
Cannot control external
decoy If you are using a FOXPRO Jack Predator Decoy, make sure
that the AUX configuration is set to momentary and not
latched. If you are using a third party decoy, try using the
latched setting instead of momentary.
Having trouble with
programming new sounds Check out FOXPRO’s website for detailed programming
information for your XWave. Solutions for many common
issues can be found there.
Poor battery life in extreme
cold weather conditions Cold weather operations can take a serious toll on alkaline
batteries. It is strongly recommended that you use lithium
or rechargeable NiMH batteries to get the best
performance in cold weather.
XWave remote will not turn
on after firmware update Contact FOXPRO technical support.
XWave will not turn on after
firmware update Contact FOXPRO technical support.
Cannot control volume on
XWave Check your XWave remote configuration to see if Auto
Volume is activated. If it is, it would seem like you have no
volume control ability.
16. Maximizing Remote Range
Remote range can be affected by many factors. Some of these factors can be controlled while
others cannot. In order to achieve the best possible remote range with your XWave digital game
call system, it is recommended that the following points be observed:
•
Always use high quality alkaline or lithium cell batteries in the remote.
•
Always maintain clear line of sight between the remote control and the XWave. Any
obstructions
— no matter how significant or insignificant — can adversely affect the
radio signal.
•
Try to keep the remote control approximately six inches away from your body, gun
barrel, and metal shooting sticks as these things can detune the remote control.
•
Hold the remote control vertically with the antenna pointing skyward.