Foxpro XWave, Instruction Manual

Page: 40 / 64

40
Turning on the Stand Timer:
1. Access the Date/Time(r) menu and select “Stand Timer”
2. Use the scroll buttons to change between off and on.
3. When set to the desired position, push “Play/Select” to lock it in.
Resetting the Stand Timer:
1. Access the Date/Time(r) menu and select “Timer Reset”
2. Push “Play/Select” to reset the timer.
To get the clock back on the display, simply set the stand timer to off.
8-2 Alarm
The XWave remote features a visual alarm that can be set to go off after a span of time. The
available times are represented in minutes: 1
– 60. When the alarm is set and the configured
time span passes, the stand timer (or clock if set to display the clock) will begin to flash alerting
you.
IMPORTANT NOTE
The alarm is based upon the stand timer only, not the real time clock. Keep in mind that the
stand timer begins tracking time as soon as the XWave remote is turned on. Make sure that
you select the
Stand Timer Reset option (described earlier on this page) when setting up the
alarm. For example, if you turn on the XWave remote and 10 minutes have passed while
getting setup, and then you set the alarm for 30 minutes, it’s going to go off 20 minutes later
unless you use the Stand Timer Reset prior after setting the alarm. Also, if the screen
timeout occurs prior to the alarm going off, it will turn back on when the alarm goes off.
Setting the Alarm:
1. Access the Date/Time(r) menu and select “Alarm”
2. Use the scroll buttons to select the desired amount of time in minutes. To shut off the
alarm, simply change the value to off.
3. Push “Play/Select” to set the alarm.
8-3 Time
The XWave remote has a real time clock. This clock must be set when you first install or change
batteries.
Setting the Clock:
1. Access the Date/Time(r) menu and select “Time”
2. Use the scroll buttons to set the current time.
3. Push “Play/Select” to lock it in.
The clock can be displayed in either the standard 12-hour format or 24-hour format (military
time).