Logging in Ethernet Switch
18
Step 3:
The Ethernet switch is powered on. Display self-test information of the Ethernet switch and
prompt you to press Enter to show the command line prompt such as < > after you have
entered the correct username and password. The initial username is admin and the matched
password is admin. It is suggested modifying the initial password after the first logging in.
Please remember the modified password. If the password is forgotten, please contact us as
soon as possible. Modify password refers to
Step 4:
Input a command to configure the Ethernet switch or Configuration Mode the operation
state. Input a “?” to get an immediate help. For details of specific commands, refer to the
following chapters.
1.2 Set up Configuration Environment
through Telnet
1.2.1 Connect PC to Ethernet Switch through
Telnet
After you have correctly configured IP address of a VLAN interface for an Ethernet Switch
via Console port (the way to configure switch via console refers to
Environment via the Console Port
; the way to configure ip address of switch refers to 03 using
ip address
command in VLAN interface mode), and make sure PC can ping the switch, then
you can telnet this Ethernet switch and configure it.
Step 1:
Authenticate the Telnet user via the Console port before the user logs in by Telnet.
Step 2:
To set up the configuration environment, connect the Ethernet port
of the PC to that of the Ethernet switch via the LAN.
W o rk s ta tio n
W o rk s ta tio n
S e rv er
P C ( fo r c o n fig u rin g th e sw itc h
v ia T e lne t )
E th e rn e t p o rt
E th e rn e t
W o rk s ta tio n
W o rk s ta tio n
S e rv er
P C ( fo r c o n fig u rin g th e sw itc h
v ia T e lne t )
E th e rn e t p o rt
E th e rn e t
Figure 1-5 Set up configuration environment through telnet
Summary of Contents for S6424-S2C2 series
Page 1: ......
