130
11.2 Commands for Mac Address Binding
configuration
11.2.1 clear port-security dynamic
Command: clear port-security dynamic [address <
mac-addr>
| interface
<
interface-id>
]
Function:
Clear the Dynamic MAC addresses of the specified port.
Command mode:
Admin Mode.
Parameter:
<mac-addr>
stands MAC address;
<
interface-id>
for specified port number.
Usage Guide:
The secure port must be locked before dynamic MAC clearing operation
can be perform in specified port. If no ports and MAC are specified, then all dynamic MAC
in all locked secure ports will be cleared; if only port but no MAC address is specified, then
all MAC addresses in the specified port will be cleared.
Example:
Delete all dynamic MAC in port1.
Switch#clear port-security dynamic interface Ethernet 1/1
11.2.2 mac-address-table periodic-monitor-time
Command: mac-address-table periodic-monitor-time <5-86400>
Function:
Set the MAC monitor interval to count the added and deleted MAC in time, and
send out them with trap message.
Parameter: <5-86400>:
the interval is 5 to 86400 seconds.
Command mode:
Global Mode.
Default:
60 seconds.
Usage Guide:
Associate this command with mac-address-table synchronizing enable
command to use.
Example:
Set the MAC monitor interval as 120 seconds.
Switch(Config)#mac-address-table periodic-monitor-time 120
11.2.3 mac-address-table synchronizing enable
Command: mac-address-table synchronizing enable
no mac-address-table synchronizing enable
Function:
Enable the monitor function for MAC, if a MAC is added or deleted, the system
will report this monitored event; the no command will cancel this function.
Summary of Contents for S6124
Page 311: ...311 Machine...
Page 314: ...314...
