Foxcom SATLIGHT 7225H, Installation And User Manual

Page: 45 / 60

7225H Interfacility Link Installation and User’s Guide page 37
Foxcom proprietary information
Appendix 3 The 2380 Relay Adapter
The following section describes how to install the 2380 Relay adapter
onto the 7180M Chassis. The 2380 Relay adapter assembly provides
dry contact output signals as an option to the standard open collector
signals available on the 7180M chassis backplane.
If the 2380 Relay adapter is ordered separately from the 7180M
chassis, it must mounted by the user. The 2380 is mounted directly
over the connectors on the 7180M backplane, as shown below.
Appendix 3.1 Installing the 2380 Relay Adapter
Appendix 3.1.1 Parts Required for Installing the 2380
• 2380 Relay Adapter
• Two pin guides
• Four one-inch screws
• Screw driver
Appendix 3.1.2 Mounting the the 2380 Relay Adapter
1.
Very Important
: Disconnect the electricity
before
performing
this procedure.
2. Make sure that you have all the needed equipment.
3. Install the pin guides.
Figure 23 Installing the guide pins